Project 1

                                                              BUTTERFLY VALVE ASSEMBLY   Objective: The objective of this project is to design the assembly of the…

                                                                        WIRING HARNESS DESIGN OF BACKDOOR AIM-      …

                                                            CAR BACK DOOR WIRING HARNESS DESIGN- PROJECT 2 AIM                To route…

                                             Wiring harness design in CATIA V5 - 3D modeling Week 7 Challenge AIM                 To prepare the flattened view of wiring…

                           WIRING HARNESS DESIGN IN CATIA V5 - 3D MODELING WEEK 5 & 6 CHALLENGE AIM                    Route two electrical harnesses as per the given layout and interconnect…

                                                                                     Wiring harness design in CATIA V5 Aim:-                     Route the following harness layout in Electrical workbench. Make assumption for harness bundle diameters. Use Following connectors as shown in layout diagram.                …

                                                                                  WIRING HARNESS ROUTING AND PACKAGING…

Aim:       Electrically defined the given connecters and connecter clip with the help of geometry and assemble by the electrical wiring harness workbench.    Wiring harness:                Systematic bound of electric…

AIM Use the provided styling surface to come up with a back door design, use appropriate design methodologies, and provide the necessary reinforcements and embosses  INTRODUCTION  BACK DOOR   Back door or tail gate  simply refers to the back of the car that can open and close.it covering the rear of the vehicle.It provide…

    ROOF DESIGN Roof is not a single element, it consists of Front roof rail, Rear Roof Rail, Bow      RoofRail, Center Roof Rail. These Bow Roofs are placed in the most Flat area of the Panel. Rear Roof Rail joins with the Back door and Body side outer. Front Roof Rail joins with the Wind shield…

Section modulus :                          It is a geometric property for a given cross-section used in the design of beams or flexural members. Other geometric properties used in design include area for tension and shear, radius of gyration for…

I COULD NOT UPLOAD IMAGES

DRAWING   1. CV JOINT PRODUCT  1. CV JOINT   2. QUICK RETURN MSM