Project 1-Meshing of Rear Wheel Holder challenge

     OBJECTIVE: To extract the mid surface of given component and mesh the component under given quality       criteria and assign thickness.

     GIVEN MODEL:

     PROCEDURE:

     Import CAD Model:

     Quality Criteria for Rear Wheel Holder Component:

     Midsurfacing extraction:

     Mid-surface can be extracted by any of the 4 methods below.

1. Offset + plane + sweep.
2. Offset + plane.
3. Offset
4. Skin Offset.

• To extract the mid-surface, go to geom ->> mid-surface ->> select any extraction option ->> select the surface ->> extract. In this project offset + plane + sweep is used.
• After extracting the mid-surface, it is checked for any geometrical errors like needle faces, missing surfaces and triple cons. If any of the errors present then it should be rectified immediately.
• Now the properties like thickness, Material etc. need to be assigned to the mid-surface. To assign the properties, select model in database and right click and choose create and then property.
• Now all the properties are entered in the property tab and the properties are assigned to the respective mid-surfaces.
• To assign the properties to mid-surface, right click on the mid-surface and then select assign and select the respective properties which needs to be assigned.

     Meshing:

• We mesh the mid surface by element size as 5 and mixed elements.
• First we should start from complex surface to get good mesh flow.
• While meshing we should maintain the tria percentage as low as possible.
• We can maintain trias in the direction of the mesh flow. 
• We should avoid opposite trias.
• Use REBUILD option for getting better mesh.
• Split the surface before start meshing it gives good mesh and fine flow.

     Quality index:

     Assign various thickness for each  parts:

• First we need to create PROPERTY and MATERIAL before assign thickness.
• Right click on tab area and select create then Property.now new property is created.
• After creating property rename it and give material, thickness, card imeage,etc...

    FINAL MODEL:

    RESULT & CONCLUSION:

    2D Shell mesh is done for given model under given criteria and thickness assigned succesfully using                Hypermesh. Learned the mesh and feature capture for complex component.