In this project, I will be simulating an incompressible-laminar-viscous flow through a backward facing step. This will be solved using the software OpenFOAM running on Debian. The solver for this simulation was chosen to be icoFoam, I decided what solver to use from this guide on OpenFOAM's website This is from their guide,…

Draft Analysis When a plastic component is made, we can observe that there is a draft angle given on each side from the base which is lesser than 90 degrees. This is because in the criteria of making a plastic material the mold should release the material when finished. if the mold surfaces are 90 degrees…

LS DYNA – Material_Modelling_Hyperelastic By Enos Leslie Mechanical Engineer 8th April 2023   AIM   Model a hyperelastic material by comparing data to stress/strain experimental curve data. The rubber models from Ls Dyna Deck considered are: Mooney Rivlin Constant (MAT_077, N = 1) Ogden Rubber Constants…

AIM: Surface meshing on a Pressure valve Objectives: To check for the geometrical errors. To perform Topology cleanup accordingly. To set three different target lengths as three different cases and mesh the model. To apply any one target length from the above at a time for the entire model as One case. To write a…

AIM: Surface meshing on a Pressure valve Objectives: To check for the geometrical errors. To perform Topology cleanup accordingly. To set three different target lengths as three different cases and mesh the model. To apply any one target length from the above at a time for the entire model as One case. To write a…