Week 10 - Challenge 3 - Door Trim Lower with Engineering Features

            REPORT: In this component, we decided to try a new approach for the tooling axis and bisecting line. Here, We have inserted the axis system, and Z-direction will be our tooling axis direction. For the ZY direction, we have taken the intersection of the switch bezel along the ZY…

     Aim : To Create the Base Bracket Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and at the end perform the Draft analysis on the model.    Steps to perform…

                                                                         BUMPER AIM  Create the Bumper Plastic component through…

        Attachment Feature Creation (Ribs & Screw Boss) AIM: To create the door handle component from the given class-A Surface. To create the tooling axis for the given class-A surface meeting the requirements of the draft angle. To attach B side features in the component. To perform the draft…

      Aim:  Create the Dog House for the Door Trim considering the design rules and perform the draft analysis for class A and create the final close body component and perform the draft analysis.   OBJECTIVES: To create the class B and class C surfaces from the given class A surface. To form a…

     AIM     To make a full solid model from the provided master section and class A surface. INTRODUCTION: CATIA:          It means Computer-Aided Three-Dimensional Interactive Application.  It is computer aided designing software. This…

                               Design of backdoor                                       Design of Backdoor using NX CAD :-   INTRODUCTION:-  Backdoor are one of the type of door of the vehicle, which are located next to the passenger seat, which provides access to the luggage compartment. In the most of the cars, these…

                               Design of backdoor                                       Design of Backdoor using NX CAD :-   INTRODUCTION:-  Backdoor are one of the type of door of the vehicle, which are located next to the passenger seat, which provides access to the luggage compartment. In the most of the cars, these…

                                     Introduction: An automobile roof is the portion of an automobile that sits above the passenger compartment, protecting the vehicle occupants from sun, wind, rain, and other external elements.…

                                                                                          …

                                               FENDER DESIGN OBJECTIVE The main objective of this project is to design a fender using a new age design software-NX-CAD INTRODUCTION: Aluminum automotive components made using a hot blow forming process are reducing vehicle weight and increasing the fuel efficiency of today’s…

                                                                                          …

                                       FENDER DESIGN - WHEEL ARCH CALCULATION   Objective: Calculate the Wheel Arc area of European Standard and prove whether the car will pass the standards or Not.      …

                          Underbody Coat            A car underbody is most prone to corrosion. Underbody coating provides long term protection from corrosion to car’s underbody. It also protects parts like internal body…

                            BENCHMARKING           WHAT IS BENCHMARKING    Automotive Benchmarking is the process of analyzing the choices of similar products based on the selection factor and deducing it to final…