Week 8 - Challenge 2 - Switch Bezel Design
I GOT A GAP IN [CLASS A] SURFACE I ALTERED THE GAP AND I CREATED A JOIN OF [CLASS A] SURFACE AFTER CREATED A [CLASS B] SURFACE AND [CLASS C]. IN [CLASS C] ALSO GOT SOME MINUTE GAP IT TOOK TIME TO ARREST. AFTER TRIM [CLASS A] TO [CLASS C] FOLLOWING TRIM TO [CLASS B]
VASANTH M
updated on 27 Sep 2022
Project Details
Leave a comment
Thanks for choosing to leave a comment. Please keep in mind that all the comments are moderated as per our comment policy, and your email will not be published for privacy reasons. Please leave a personal & meaningful conversation.
Other comments...
Be the first to add a comment
Read more Projects by VASANTH M (10)
Underbody Coating
What is under Body Coating: Underbody coating is a thick cladding (typically made of rubber) that is placed uniformly on the car’s underside. When the automobile is fresh off the lot and spotless, it is usually sprayed or painted on. But it’s acceptable if you apply the undercoating after a couple of years.…
29 Nov 2022 04:11 PM IST
Benchmarking
Objective: 1. What is Benchmark and presently available cars with benchmarking in the market, also explaining the below following case 2. Comparing at least 4 vehicles. 3. Provide a proper conclusion for the report, suggesting a single suitable vehicle among the comparison made with images. Given Case: Mr. D.S. Pughazhyendhii is…
29 Nov 2022 03:59 PM IST
Week 9 - Project - A pillar Design with Master Section
AIM To make a full solid model from the provided master section and class A surface. INTRODUCTION: CATIA: It means Computer-Aided Three-Dimensional Interactive Application. It is computer aided designing software. This is software which…
19 Nov 2022 06:39 AM IST
Week 9 - Attachment Feature Creation - Challenge 2
AIM To make a fully solid model from the provided lower door trim A surface and make DOG HOUSE. INTRODUCTION: CATIA: It means Computer-Aided Three-Dimensional Interactive Application. It is computer-aided designing software. This is software which is used to design 3D models with different workbenches.…
17 Nov 2022 04:28 AM IST
Week 9 - Attachment Feature Creation (Ribs & Screw Boss) - Challenge 1
16 Oct 2022 06:56 PM IST
Week 8 - Challenge 6 - Core & Cavity Design
15 Oct 2022 11:57 AM IST
Week 8 - Challenge 4 - Bumper
12 Oct 2022 04:07 PM IST
Week 8 - Challenge 3 - Coin Holder Design
12 Oct 2022 03:57 PM IST
Week 8 - Challenge 2 - Switch Bezel Design
I GOT A GAP IN [CLASS A] SURFACE I ALTERED THE GAP AND I CREATED A JOIN OF [CLASS A] SURFACE AFTER CREATED A [CLASS B] SURFACE AND [CLASS C]. IN [CLASS C] ALSO GOT SOME MINUTE GAP IT TOOK TIME TO ARREST. AFTER TRIM [CLASS A] TO [CLASS C] FOLLOWING TRIM TO [CLASS B]
27 Sep 2022 05:59 PM IST
Week 8 - Challenge 1 - Base Bracket Design
25 Sep 2022 09:36 AM IST