PART 1 - SI-PFI Engine - Surface prep, Boundary flagging & No-Hydro Case setup ****************************************************************************************** I. INTRODUCTION After Post-processing the No-Hydro setup & verifying the case parameters runs as specified, the part 2 of this project advances…

I. INTRODUCTION Compression ignition engine (Diesel engine) as the name suggests is an engine where fuel-injection takes place into the engine cylinder toward the end of compression stroke, just before the desired start of combustion. A closed cycle sector analysis of the cylinder is performed in this project as the main…

PART 2 - Multidimensional Simulation of SI-PFI Engine using Converge CFD (FULL-HYDRO CASE) **************************************************************************************** I. INTRODUCTION  Port-fuel-injection engine as its name suggests is an engine where fuel is injected in the port i.e in its intake port…

I. Introduction:  In this Project, A Steady & Transient state simulation is done of a Flow through an Elbow joint consisting of a throttle valve. The steady state case is solved with the Throttle valve fully open until convergence is reached. While the Transient case is ran with the throttle valve rotating i.e…

Channel flow case- Assignment 1  

Channel flow case- Assignment 1