Menu

Executive Programs

Workshops

Projects

Blogs

Careers

Student Reviews



More

Academic Training

Informative Articles

Find Jobs

We are Hiring!


All Courses

Choose a category

Loading...

All Courses

All Courses

logo

PARAVIEW Projects

MULTI DIMENSIONAL SIMULATION OF A PORT FUEL INJECTED ENGINE(PART 1)
Abstract :   Computational fluid dynamics (CFD) is a branch of science that deals with the simulation of fluid flow and there are many softwares which deals with multi phase fluid flow, flow through complex geometries. The software best for simulating the flow through complex I.C engine geometry is CONVERGE STUDIO…
  • CFD
  • COMBUSTION
  • PARAVIEW

Project submitted by -

submitdetails

Mehul

Know more
PART 1 - SI-PFI Engine - Surface prep, Boundary flagging & No-Hydro Case setup ****************************************************************************************** I. INTRODUCTION After Post-processing the No-Hydro setup & verifying the case parameters runs as specified, the part 2 of this project advances…
 Aim: To simulate flow through a pipe in OPENFOAM and validate the results.   Objectives:  1. To validate of hydrodynamic length with the numerical result. 2. Validate the fully developed flow velocity profile with its analytical profile. 3. Validate maximum velocity and pressure drop for fully developed…
I. INTRODUCTION Compression ignition engine (Diesel engine) as the name suggests is an engine where fuel-injection takes place into the engine cylinder toward the end of compression stroke, just before the desired start of combustion. A closed cycle sector analysis of the cylinder is performed in this project as the main…
Aim: To simulate flow through a pipe in OPENFOAM and validate the results.   Objectives:  1. To validate of hydrodynamic length with the numerical result. 2. Validate the fully developed flow velocity profile with its analytical profile. 3. Validate maximum velocity and pressure drop for fully developed flow. 4. Post process…
OBJECTIVE:- (I) TO SETUP FULL HYDRO SIMULATION FOR THE PORT FUEL INJECTION ENGINE.  (II) POST-PROCESSING OUTPUT FROM SIMULATION AND CALCULATING :- (A) COMPRESSION RATIO OF THE ENGINE. (B) COMBUSTION EFFICIENCY OF THE ENGINE. (C) TO DETERMINE POWER AND TORQUE OF ENGINE USING PERFORMANCE CALCULATOR.   INTRODUCTION:- …