Week 10 - Challenge 3 - Door Trim Lower with Engineering Features

The butterfly valve assembly     

Aim      To create a back door using the given styling surface by following the design standards and to provide necessary reinforcements and embosses in crucial regions of the inner panel of the back door.  DESIGN OF BACK DOOR      The rear door of an automobile is a crucial component…

ROOF DESIGN INTRODUCTION       The vehicle's total structural strength is greatly enhanced by the car roof, especially in the case of an impact or rollover. Engineers use cutting-edge materials like high-strength steel or aluminium alloys in their meticulous construction of the roof to ensure that it can…

FENDER DESIGN AIM            To design a fender using the given master section by following the design considerations. INTRODUCTION             An automobile's fender is an essential component of both its external appearance and operation. Fenders serve a…

SECTION MODULUS                  It is the ratio of area moment of inertia about the neutral axis and to the distance of outermost fibre from the neutral axis.                     Section modulus is the direct Measure…

HOOD ASSEMBLY                   From the given class A surface (outer panel) ,the inner panel is made by following the design requirements and necessary embosses and cut outs are made acording to the design norms. Hinges are mounted on the inner panel by creating seperate embosses…

DOOR TRIM PANEL                  The given class A surfaces are thickened according to the master section dimensions. All the parts has undergone draft analysis and it detailed in the report. All the flanges are created according to the master section in all the parts. The heat…

Output Required in a ppt : Picture of the sketches with Sketch solving status’s geometry tab Picture of the Detailed tree structure. Picture of the 3D CAD Create closed body  Create a tooling axis and follow design rules. Follow the Master section to create a flange Follow the master section for thickness and…

DRAFT ANALYSIS               Draft analysis is done on the class A surface and it clears all the manufacturing needs.Class B surface and class C surface is created and it is finally all the surfaces are trimmed together to form plactic component. Heat stakes are made on all the required…

DOH HOUSE                  Two tooling axis is provided to the dog house. 1.5 degree draft is given to the walls of the dog house as per the standards. Another tooling is provided for the side core movement. Draft analysis is done on the side core tooling axis and it passes…

DRAFT ANALYSIS                 From the draft analysis it is seen that the 2.5 degree is given to the class A surface. From the thorough inspection tooling axis is found and it is made according to the manufacturing norms of injection moulding. An certain angle is provided on the…

DRAFT ANALYSIS                 From the draft analysis it is seen that the 2.9 degree is given to the class A surface. From the thorough inspection tooling axis is found and it is made according to the manufacturing norms of injection moulding. An certain angle is provided on the…

DRAFT ANALYSIS                 From the draft analysis it is seen that the 2.9 degree is given to the class A surface. From the thorough inspection tooling axis is found and it is made according to the manufacturing norms of injection moulding. An certain angle is provided on the…

Tree Structure Ensure Proper Tree Structure Geometrical sets should have a proper name based on the sketches present inside of it All the sketches should be created under the Geometrical set  Use the Close Surface feature to make a solid body from the surface.  Publications: Use the publication option…

ASSEMBLY CHALLENGE ON CV JOINT AND QUICK RETURN MECHANISM